Full Product Manual

10
Figure 5
4. Guide blade through slot in vertical cutting
plate (D, Figure 5), and tighten with the two
screws.
5. Verify that vertical cutting plate is square to
blade, using a machinist’s square on the plate
and against the blade (Figure 6).
Figure 6
6. If adjustment is needed, loosen screws and
place shims where required. Tighten screws.
7. Place a level on vertical cutting plate (Figure
7).
Figure 7
8. Turn stop screw (J, Figure 8) as needed, until
cutting plate is level. Tighten hex nut.
9. Close valve on cylinder (lever perpendicular to
cylinder) to secure bow in position.
Reinstall seat plate before using bow in horizontal
position.
Figure 8
7.5 Coolant system
Make sure there is coolant in
the tank before operating, to prevent damage to
pump.
Use of a water-soluble coolant will increase cutting
efficiency and prolong blade life. Do not use black
cutting oil as a substitute.
1. Remove coolant return hose (A, Figure 9) from
filter cup, and slide tank out of saw base.
2. Fill tank to approximately 80% of capacity. Full
capacity is 9 liters (2.25 gal).
3. Place tank into base. Place coolant return
hose into the filter cup. Verify that opposite
end of coolant return hose is connected to the
coolant pan.
4. The coolant supply hose (B, Figure 9) should
connect to the taps on the blade guide
assemblies.
Figure 9