Full Product Manual

7.0 Set-Up and Assembly

7.1 Unpacking and cleanup

Inspect contents of shipping container for shipping

damage. Report any damage to your distributor.

Remove all contents from carton, and compare to

the contents list in this manual. Report any part

shortages to your distributor. Do not discard carton

or packing material until machine is assembled and

running satisfactorily.

Exposed metal areas have a rust preventative

applied. Remove this with a soft rag and solvent or

degreaser. Do not use cellulose-based solvents

such as paint thinner or lacquer thinner; these will

damage painted and plastic surfaces.

7.2 Shipping contents

If you do not see a part below, check the machine;

some parts may have come pre-assembled to the

saw.

Refer to Figures 2 and 3.

1 Band Saw

1 Workstop – A

1 Workstop rod – B

1 Filter screen – C

1 Vertical cutting plate – D

1 Handle – E

1 Axle – F

2 Wheels – G

1 Foot stand – H

1 Instructions and Parts Manual (not shown)

1 Warranty Card (not shown)

Hardware Package (p/n HBS812G-HP):

2 Hex cap screws 1/4"x3/4" – HP-1

2 Lock washers 1/4" – HP-2

2 Flat washers 1/4" – HP-3

4 Hex cap screws 5/16"x1-1/2" – HP-4

4 Lock washers 5/16" – HP-5

4 Flat washers 5/16" – HP-6

4 Hex nuts 5/16" – HP-7

2 Cotter pins – HP-8

2 Flat washers 1/2" – HP-9

Tools required for assembly:

(2) 12mm wrenches

10mm wrench

Pliers

Figure 2

Figure 3

Hardware package HBS812G-HP