Full Product Manual

6
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or
possible machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly
even death.
Introduction
The JET Model J-7015 Horizontal Cut-off Bandsaw is designed for high production cut-off work. Four
cutting speeds and a hydraulic feed control allow the efficient cutting of virtually any material.
The Model J-7015 Horizontal Cut-off Bandsaw is equipped with a coolant system that can greatly extend
blade life and speed the cutting of a variety of materials that are best cut with cutting fluids and coolants.
Specifications
Model Number ............................................................................................................................... J-7015
Stock Number................................................................................................................................ 414450
Capacity:
Rectangular Stock at 90° (in.) ...................................................................................................... 9 x 13
Rectangular Stock at 45° (in.) .......................................................................................................9 x 8
Round Stock at 90° (in.) ...................................................................................................................... 9
Round Stock at 45° (in.) ...................................................................................................................... 9
Flat Stock (in.) .............................................................................................................................8 x 10
Speeds (FPM) ................................................................................................................ 82, 132, 170, 235
Motor ........................................ TEFC, 1-1/2 Horsepower, Capacitor Start, 1725 RPM, 1 Phase, 115/230V
Blade Size (in.) ............................................................................................................... 1 x 0.035 x 114.5
Blade Guides ............................................................... Tungsten carbide tip & ball bearing, eccentric shaft
Material ........................................................................................................... Tungsten carbide inserts
Sides ........................................................................................................ Eccentric shaft, ball bearings
Blade Wheel (in.) ................................................................................................ 11-5/8 diameter, cast iron
Dimensions (LxWxH)(in.) ....................................................................... 62.5 x 22.4 x 48.4 (cutoff position)
Net Weight, approx. (lbs.) .................................................................................................................... 551
Vise ..................................................................................................... Rapid acting, screw tightening vise
Coolant Pump..................................................................................... 1/8 Horsepower, 1Phase, 115/230V
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.