Warranty

19
5. Open the valve on the hydraulic cylinder to
allow the bow to descend in a gradual and
controlled manner.
6. The machine will shut off at the completion
of the cut. Remove the workpiece.
7. Close the hydraulic cylinder valve, and raise
the bow in preparation for the next cut.
Maintenance
Before doing maintenance on
the machine, disconnect it from the electrical
supply by pulling out the plug or switching
off the main switch. Failure to comply may
cause serious injury.
Clean the machine of chips, shavings, etc. with
a rag or brush. Do not use your hands.
If the power cord is worn, cut, or damaged in
any way, have it replaced immediately.
The ball bearings on the blade guide assemblies
are self-contained and sealed. They require no
further lubrication.
Occasionally grease the lead screw on the vise.