Full Product Manual

12
If the power cord is worn, cut, or damaged in any
way, have it replaced immediately.
13.1 Lubrication
All ball bearings are permanently lubricated and
sealed. They require no further attention.
The gear box lubricant should be changed after the
first 50 hours of operation. Change lubricant from
then on every 250 hours of operation.
To check level of gear box lubricant, place saw arm
in down position and allow a few minutes to pass
so that oil drains down. Check level in sight glass
on side of gear casing. Correct level is the dot in
the middle of sight glass.
To change gear box lubricant:
1. Disconnect machine from the power source.
2. Open drain plug and allow lubricant to drain
completely. Drain plug may be found on lower
front of gear case under right wheel cover.
Remove drain plug with a hex wrench.
3. Replace drain plug.
4. Remove filler cap (A, Figure 12) and fill gear
box with Mobil DTE® Oil Heavy Medium until
level reaches dot in middle of sight glass.
5. Replace filler cap.
6. Connect machine to the power source.
Use a light machine oil to lubricate all other moving
parts as needed.
Figure 12













14.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-
800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial
Number of your machine available when you call will allow us to serve you quickly and accurately.