This .pdf document is bookmarked Operating Instructions and Parts Manual AHR-50 Auto Rewind Hose Reel JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
Table of Contents Section Page AHR-50 Auto Rewind Hose Reel .......................................................................................................................... 1 Warranty and Service ............................................................................................................................................ 2 Table of Contents ...............................................................................................................................................
Note: A swivel connector and flexible inlet hose are required for supply line or warranty is void. Safety Precautions 5. Flush some product through the system and reel prior to connecting outlet nozzle to tool. Apply thread seal tape or pipe sealant to outlet fitting on reel hose, and then attach to desired tool, or nozzle. Check connection for leakage using soapy water. 6. If hose stopper adjustment is required, pull hose from reel and allow latching at desired length.
. Use the hose guard and hose stop from the old hose and place in the same position on the new hose. 6. Feed new hose through guide and opening in drum, and connect to swivel. Use thread sealant on the threads. 7. Re-install two hose clamps, on inside and outside of drum flange. 8. Carefully release the drum latch, and slowly allow the hose to wind onto the reel. Spring Tension Adjustment 1. Pull out approximately 6 feet, or 2 meters of hose and allow the drum to latch. 2.
Troubleshooting the AHR-50 Auto Rewind Hose Reel Symptom Possible Cause Correction Hose will not fully retract. Outlet nozzle, gun or tool is too heavy. Add spring tension. See "Spring Tension Adjustment.” Spring is fatigued. Add spring tension. See "Spring Tension Adjustment.” Replace spring canister if required. Replacement hose is too long. Call local Distributor for correct specified hose length. Hose will not retract at Spring has lost all tension or has Reinstall spring tension. all.
AHR-50 Hose Reel – Exploded View 7
AHR-50 Hose Reel – Parts List Index No. Part No. Description Size Qty. 1 ................ AHR50-1 ................... Base......................................................................... ...................................... 1 2 ................ AHR50-2 ................... Support Plate ........................................................... ...................................... 1 3 ................ AHR50-3 ................... Guide Plate ..................................................
Index No. Part No. Description Size Qty. 57 .............. AHR50-57 ................. Spring Drum Label * ............................................... ...................................... 1 59 .............. AHR50-59 ................. Arrow Label * ......................................................... ...................................... 1 .................. AHR50-ID .................. JET I.D. Label (not shown) ...................................... ...................................... 1 .
Mounting Template 10
427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.
