Use and Care Manual

JET
5
Tool specifications
Model number JCT-1600 JCT-1601 JCT-1602
Stock number 550600 550601 550602
Type Bench Bench Bench
Impact rate (blows per minute) 1,500 1,000 800
Piston stroke 2 in. 2-9/16 in. 3-15/16 in.
Bore 18 mm 22 mm 25.4 mm
Taper 1.44 deg. 1.38 deg. 1.39 deg.
Butt type Rubber Rubber Rubber
Butt diameter 1-11/16 in. 2-3/64 in. 2-9/16 in.
Average air consumption 14 CFM 17 CFM 24 CFM
Air Inlet 1/4 in. NPT 3/8 in. NPT 3/8 in. NPT
Air hose minimum inside dia. 3/8 in. 3/8 in. 3/8 in.
Required air pressure 90 psi (6.2 bar) 90 psi (6.2 bar) 90 psi (6.2 bar)
Vibration value 35.04 m/s
2
33.84 m/s
2
32.49 m/s
2
Noise level
1
100.4 dB(A) 102.9 dB(A) 104.7 dB(A)
Overall length 11~14-1/4 in. 14-1/2~18-1/2 in. 19-11/16~26 in.
Housing material steel steel steel
Net weight 3.53 lb. (1.6 kg) 6.5 lb. (2.95 kg) 13.23 lb. (6 kg)
Shipping weight 4.5 lb. (2 kg) 7.5 lb. (3.4 kg) 15 lb. (6.8 kg)
1
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As
workplace conditions vary, this information is intended to allow the user to make a better estimation of the
hazards and risks involved only.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET
reserves the right to change specifications at any time and without prior notice, without incurring obligations.