Use and Care Manual

22. If the drive disc does not have a grinding disc

installed on it – install a disc now, using the

instructions in sect. 9.1 Removing and

replacing grinding discs.

23. Slide the motor forward on the frame until the

disc is 1/8-inch from the table. Be certain that

both the right and left hand gaps between the

table and disc are equal.

24. Tighten the motor mounting bolts securely.

25. Reconnect the machine to its electrical power

source.

26. Verify the motor and disc rotation. If you have

connected everything correctly, the disc will

rotate clockwise when viewed from the front. If

the disc rotates counterclockwise, correct the

electrical connections according to instructions

in sect. 6, Electrical.

27. The machine is ready to return to service.

10.0 Lubrication

Since the grinder operates in an environment of

high amounts of dust and grit, most lubrication

would simply pick up the grit and cause increased

wear to the machine and its parts. Therefore, the

primary method of keeping the machine working

surfaces in good order is KEEPING THE

MACHINE AS CLEAN AS POSSIBLE. Before

using the tilt table or table raising mechanism the

operator should use a stiff brush to remove

excessive dust and grit from the tilt worm-and-

sector and/or table raising rack. The single

exception to this "no-lubrication" recommendation

is the right angle drive used for the table raising

rack-and-pinion system. This gearbox is pre-

lubricated at the factory and should require no

additional lubrication unless it is disassembled. If

this is done, use Shell Retinax A or a similar

grease to refill the gearbox.

11.0 Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-

800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial

Number of your machine available when you call will allow us to serve you quickly and accurately.

Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.

Some parts are shown for reference only, and may not be available individually.