Use and Care Manual
Table Of Contents
- 2 x 72-inch Square Wheel Belt Grinder
- 1.0 IMPORTANT SAFETY INSTRUCTIONS
- 2.0 About this machine and manual
- 3.0 Table of contents
- 4.0 Specifications for SWG-series Grinders
- 5.0 Setup and assembly
- 6.0 Electrical connections
- 7.0 Adjustments
- 8.0 Operation
- 9.0 User-maintenance
- 10.0 Optional accessories
- 11.0 Troubleshooting SWG-series Square Wheel Grinders
- 12.0 Replacement Parts
- 12.1.1 SWG-272 Square Wheel Belt Grinder – Exploded View
- 12.1.2 SWG-272 Square Wheel Belt Grinder – Parts List
- 12.2.1 SWG-272 Motor Assembly – Parts List and Exploded View
- 12.3.1 SWG-272 Push Button Switch Assembly – Parts List and Exploded View
- 12.4.1 SWG-272VS Square Wheel Belt Grinder – Exploded View
- 12.4.2 SWG-272VS Square Wheel Belt Grinder – Parts List
- 12.5 SWG-272VS Motor Assembly – Parts List and Exploded View
- 12.6 SWG-272VS Control Switch Assembly – Parts List and Exploded View
- 12.7 Idler Housing Casting Assembly (all models) – Parts List and Exploded View
- 12.8 Platen Assembly (all models) – Parts List and Exploded View
- 12.9 Contact Wheel Assembly (all models) – Parts List and Exploded View
- 12.10 Dust Hood Assembly (all models) – Parts List and Exploded View
- 13.0 Electrical Connections
- 14.0 Warranty and Service
7
1
subject to local/national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, Dia. = diameter
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
4.1 Hole spacing, SWG-272 / -272VS
Figure 4-1
All dimensions millimeters