Use and Care Manual

10
Handwheel Installation
Mount the handwheel to the top of the height
adjustment screw (Figure 4). Align one of the set-
screws with the flat on the height adjustment screw,
and tighten both set-screws.
Install the knob to the threaded hole in the
handwheel, and tighten the hex nut against the
handwheel.
Conveyor Table Installation
1. Lower the table mounting brackets by rotating
the handwheel.
Referring to Figure 5:
2. Place the conveyor table (O) on the mounting
brackets of the stand. The gear motor should
be on the right as shown.
3. Secure the conveyor table with four each
3/8”x1” hex cap screws (B), 3/8” flat washers
(H) and 3/8” flanged lock nuts (E).
4. Plug the motor cord into the control box
receptacle (Figure 6).
IMPORTANT: The conveyor belt has been
overtightened for shipping purposes. It must be
tensioned properly before operating the sander!
See Conveyor Belt Tension and Tracking on
page 19.
Infeed and Outfeed Table Installation
Referring to Figure 7:
1. Remove the lower hex cap screw (C) and
square nut (L) from the rail on the infeed side of
the sander.
2. Slide a left hand mounting bracket (S) into the
end of the rail.
3. Align holes and re-install the hex cap screw (C)
and square nut (L). Install a 3/8”x1” hex cap
screw (B), 3/8” flat washer (H) and flanged lock
nut (E).
4. Tighten the hex cap screw (C) first to align the
bracket, then tighten the flanged lock nut (E) on
the 3/8” screw.
5. Install a right hand mounting bracket (T) in the
same manner.
Note: You will have to open the control box to
remove the screw from the rail – remove the
front lower screw and base panel (Item # 16 on
page 39) of the control box.
6. Position the table (U) over the brackets (S,T)
and install four each 1/4”x3/4” carriage
bolts (D), 1/4” flat washers (K), and 1/4” hex
nuts (J). Do not fully tighten yet.
Figure 4
Figure 5
Figure 6