Use and Care Manual

8
Unpacking
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Hardware
Hardware
Note: The letter designators identifying parts on
this page are used throughout this manual for
reference convenience.
08 Hex Cap Screw, 3/8”x1-1/2” (A)
08 Hex Cap Screw, 3/8”x1” (B)
02 Hex Cap Screw, 5/16”x3/4” (C)
08 Carriage Bolt, 1/4"x3/4" (D)
16 Flanged Lock Nuts, 3/8” (E)
04 Hex Nut, 1/2" (F)
04 Flat Washer, 1/2" (G)
16 Flat Washer, 3/8" (H)
08 Hex Nut, 1/4" (J)
08 Flat Washer, 1/4" (K)
02 Square Nut, 5/16" (L)
02 Drum Alignment Templates (M)
01 Owner's Manual (not shown)
01 Warranty Card (not shown)
Contents of the Shipping Container
01 Drum Sander with stand (N)
01 Conveyor Table Assembly (O)
01 Handwheel Knob (P)
01 Handwheel (Q)
04 Legs (R)
02 LH Mounting Bracket (S)
02 RH Mounting Bracket (T)
02 Infeed/Outfeed Table (U)
02 Open-end Wrenches, 9/16", 1/2" (V)
04 Caster (W)
02 Hex Wrenches, 4mm and 1/8” (X)
01 TufTool (Y)
02 Assembly Fixtures (Z
1
)and Plywood (Z
2
)
Shipping Contents