Use and Care Manual
Table Of Contents
- Sliding Dual-Bevel Compound Miter Saw
- 1.0 IMPORTANT SAFETY INSTRUCTIONS
- 2.0 Table of contents
- 3.0 About this manual
- 4.0 Features and terminology
- 5.0 Specifications
- 6.0 Setup and assembly
- 7.0 Electrical connections
- 8.0 Adjustments
- 9.0 Operation
- 10.0 User-maintenance
- 11.0 Crown molding charts
- 12.0 Troubleshooting JMS-10X,12X Miter Saws
- 13.0 Replacement Parts
- 13.1.1 JMS-10X (#707210) – Miter Saw Assembly – Exploded View I
- 13.1.2 JMS-10X (#707210) – Miter Saw Assembly – Exploded View II
- 13.1.3 JMS-10X (#707210) – Miter Saw Assembly – Parts List
- 13.2.1 JMS-12X (#707212) – Miter Saw Assembly – Exploded View I
- 13.2.2 JMS-12X (#707212) – Miter Saw Assembly – Exploded View II
- 13.2.3 JMS-12X (#707212) – Miter Saw Assembly – Parts List
- 14.0 Electrical Connections – JMS-10X,12X
- 15.0 Warranty and service
19
11.0 Crown molding charts
11.1 Crown molding: 90° wall angles
Crown molding compound cut with 90° walls.
Type of Cut Key
Bevel
Setting
Miter
Setting Procedure
Inside corner – Left
Side
IL 33.9° 31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
Inside corner – Right
Side
IR 33.9° 31.6° Left 1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
Outside corner – Left
Side
OL 33.9° 31.6° Left 1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
Outside corner –
Right Side
OR 33.9° 31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece
Table 4