Use and Care Manual

10
7.3 Jointer-Planer assembly
Refer to Figure 9:
Fence
1. Attach jointer fence (A) to back of jointer
outfeed table (D3) with two each socket head
cap screws (Q) and lock washers (S). Tighten
screws with 5mm hex wrench (provided).
Figure 9
Lock Knobs
The JJP-8BT Jointer-Planer comes equipped with
two lock knobs to secure the position of the jointer
infeed table.
2. Install jointer infeed table lock knobs (K, T).
Note: The shaft length of the two lock knobs
(refer to Figure 2) is different. Be sure to install
each in the correct location.
Extension Table
3. Attach the planer outfeed extension table (F)
to the planer table (D5) with three socket head
cap screws (R), six flat washers (T), three lock
washers (S) and three hex nuts (U).
Screws (R) and flat washers T1 are inserted
through the extension table (F) and planer
table (D5), then fastened from inside the planer
table (D5) with flat washers (T2), lock washers
(S) and hex nuts (U).
4. Tighten screws with 5mm hex wrench and
10mm open end wrench.
Extension Table Adjustment
Two setscrews located underneath the extension
table (F) are used to adjust the height position of
the outer (protruding) edge, which must be slightly
higher than the main table (D5) in order to minimize
snipe (see sect.12.5, Avoiding Snipe).
5. Using a 4mm hex wrench (provided), turn
setscrews slightly clockwise to raise the table
or counterclockwise to lower the table.
Lock Handle
Refer to Figure 10:
6. Attach planer table lock handle (N) and flat
washer (M).
Cutterhead Guard
7. Install cutterhead guard (C) by securing the
bracket (C1) to the side of the jointer infeed
table (D5) with two each pan head machine
screws (O) and hex nuts (P).
Important: It is extremely important that spring
action causes the cutterguard (C) to retract
against the fence (A), concealing the cutterhead
(A
1). If spring return tension is not enough,
adjust the spring located on the cutterhead pivot
shaft accordingly
Figure 10
8.0 Jointer setup
Disconnect machine from
power source before making any adjustments.
Failure to comply may cause serious injury.
Refer to Figure 11:
1. Loosen lock handle (N).
2. Install planer table height adjustment handle
(L).
3. Turn handle (L) counterclockwise and lower
planer table (D
1) all the way.
4. Remove hex nut (B1) and flat washer (B2) from
dust chute (B).
5. Orient the dust chute (B) as shown and install
into the infeed opening.
Position the chute (B) such that the two
positioning keys and one threaded positioning