Use and Care Manual

7
6.0 Setup and assembly
6.1 Unpacking and cleanup
Remove all contents from the shipping carton. Do
not discard the carton or packing material until your
Model JJP-8BT Jointer-Planer is assembled and is
running satisfactorily.
Compare the contents of the carton against the list
of parts in Contents of Shipping Container (below).
The letter identification in the list corresponds to
the items shown at right. This is your key for
identifying the parts used throughout the Assembly
section for easy reference.
Remove the protective coating that is applied to the
table with a household grease and spot remover.
6.2 Contents of main carton
01 Jointer Fence – A
01 Dust Chute – B
01 Cutterhead Guard – C
01 Jointer-Planer – D
01 2-1/2" to 4" Hose Adapter – E
01 Planer Outfeed Table Extension – F
01 Owner's Manual – G
02 Push Blocks – H
01 Warranty Card (not shown)
Figure 1 – Contents of the Main Carton
Knobs and Handles
01 Lock Knob (p/n JJP8BT-90L) – J
01 Lock Knob (p/n JJP8BT-90S) – K
01 Elevating Handle (p/n JJP8BT-19A) – L
01 Flat Washer, 6mm – M
01 Lock Handle (p/n JJP8BT-25A) – N
Figure 2 – Knobs and Handles
Hardware
02 Pan Head Machine Screw – O
02 Hex Nut – P
02 Socket Head Cap Screw, M6x25 – Q
03 Socket Head Cap Screw, M6x10 – R
05 Lock Washer, 6mm – S
06 Flat Washer, 6mm – T
03 Hex Nut, M6 – U
Figure 3 – Hardware
(included in JJP10BT-HP Hardware Package)
Tools Included
01 Knife Setting Gauge – V
01 3, 5, 6mm hex wrenches (set of 3) – W
01 8/10mm Open-end Wrench – X
Figure 4 – Tools Included