Use and Care Manual

13
11.0 Operating controls
Disconnect machine from power
source before making any adjustments. Failure
to comply may cause serious injury.
11.1 Power
Plug power cord into outlet.
Referring to Figure 11:
Start/Stop
Pull the red switch (A) out to start. Push in to stop.
Safety key
Removing the safety key (B) will render the
start/stop switch inoperable. The machine can
continue to operate without the key, but upon
stopping cannot be restarted until it is reinstalled.
Reset switch
If the machine should come to an unexpected stop
during operation due to overload or jammed work-
piece, etc.:
1. Set the start/stop switch (A) to stop position
(pushed in).
2. Momentarily press, then release, the reset
switch (C).
3. Restart machine.
11.2 Planer controls and adjustments
Referring to Figure 12:
11.2.1 Table lock
Turn the lock handle (A) counterclockwise to release
and permit table adjustment. Turn the lock handle
(A) clockwise to secure the planer table (D) in its
selected position.
11.2.2 Table height adjustment
The planer table height is set as follows:
1. Unlock the table lock (A).
2. Install the removable adjustment handle (C)
onto the shaft (B).
3. Rotate the adjustment handle (C) clockwise to
raise the planer table (D), counterclockwise to
lower.
Each revolution of the adjustment handle (C) results
in a 3/32" up or down movement of the table (D). A
scale indicates the amount of table travel. The pointer
(E) indicates the table position on the scale relative to
the cutterhead.
Figure 11
Figure 12