Use and Care Manual

13
5. Under no circumstances should a small
workpiece be shaped against the collars as
shown in Figure 13.
Figure 13
10.4 Collar Positioning
Collars may be positioned above, below, or
between two cutters:
1. When using the collar below the cutter, Figure
14, the progress of the cut can be observed at
all times. A disadvantage of this method is any
accidental lifting of the work will gouge the
wood and ruin the workpiece.
Figure 14
2. Using the collar above the cutter, Figure 15,
offers the advantage of the cut not being
affected by slight variations in the stock's
thickness. However, the cut is not visible
during the operation. Another advantage is
accidental lifting of the work piece will not
gouge the work piece. Simply correct the
mistake by repeating the operation.
Figure 15
3. The collar between cutters method, shown in
Figure 16, has both the advantages and
disadvantages of the first two methods. This
method is used primarily where both edges of
the work are to be shaped.
Figure 16
10.5 Starting Pin
Using the starting pin should
only be attempted by advanced users. If you
have never used this method before, it is
recommended you get training from a qualified
person who is knowledgeable in starting pin
shaping. Failure to comply may cause serious
injury.
The starting pin is placed in one of the threaded
holes in the table:
1. Work should be placed in the first position
using the guide pin as support, as shown in
Figure 17. Then swing the work into the cutter
as shown in the second position. The work will
now be supported by the collar and starting
pin.
Figure 17
2. After the cut has been started, the work is
swung free of the starting pin and rides only
against the collar as shown in the third position
in Figure 18. Always feed against the action of
the cutter.
Figure 18