Use and Care Manual

8
6.0 Setup and assembly
6.1 Shipping contents
(see Figures 1 and 2)
1 Shaper
Box 1
1 Dust Chute
2 Ratcheting Handles
2 Handwheel Handles
2 1/2" & 3/4"Spindles
2 Knobs
2 Washers
1 Draw Bar & Nut
1 Spindle Guard Assembly
1 Arbor Wrench
1 Open End Wrench
Box 2
2 Fence Assemblies
1 Miter Gauge Assembly
2 Angle Hex Wrenches
2 Hold-down Assemblies
1 Starting Pin (not shown)
Box 3
1 Extension Wing (not shown)
Box 4
1 Rear Door (not shown)
2 Pins (not shown)
Figure 1
Figure 2
6.2 Unpacking and cleanup
1. Finish removing all contents from the shipping
container. Do not discard any shipping
material until the shaper is set up and running.
2. Inspect contents for shipping damage and
report any damage to your distributor.
3. Clean all protected parts with kerosene. Do not
use gasoline, paint thinner, or any cellulose-
based solvent. These will damage painted
surfaces and melt plastic.
6.3 Assembly
1. Attach table extension wing to the shaper table
using three hex cap bolts and three washers.
2. Attach the rear door to the shaper cabinet
using two pins.
3. Attach the chrome handle to the raising and
lowering handwheel located on the front of the
machine.
4. Attach the plastic handle to the motor bracket
plate.
5. Place the dust chute (A, Figure 1) on the table
and secure by threading two ratcheting
handles (B, Figure 1) into the tabletop.
Figure 1
6. Secure the spindle guard assembly to the dust
chute using two knobs and two washers (C,
Figure 1). Note: You should first attach the
wood piece to the two brackets with four wood
screws. Then attach the wood and brackets to
the plate guard using two screws and washers.
7. Place the fence bracket assembly (A, Figure 2)
on the table and secure by threading
ratcheting handle (B, Figure 2) into dust chute.
8. Tighten hex cap bolt (C, Figure 2) into the dust
chute using a 14mm wrench.
9. Attach the wooden fence (D, Figure 2) to the
fence bracket assembly using two countersink
flat head screws (E, Figure 2), two large flat
washers, two lock washers and two hex nuts.