Use and Care Manual

Levers and Controls

Specifications

Model JJ-8CS JJ-8HH

Stock Number – Bed and Stand Kit ................................ 708458K................................................ 708468K

Stock Number – Bed Assembly ..................................... 708458J................................................. 708468J

Stock Number Stand...................................................... 708458S................................................ 708460S

Cutting Capacity ....................................................... 8"W x 1/2"D........................................... 8"W x 1/2"D

Cutterhead Speed ...................................................... 5500 RPM.............................................. 5500 RPM

Number of Knives ...................................................................... 3....................................... 36 knife inserts

Rabbeting Capacity .............................................................. 1/2"......................................... not applicable

Rabbet Ledge ........................................................ 3-1/8" x 8-3/4"........................................ 3-1/8" x 8-3/4"

Table Surface .......................................................9”W x 66-1/2”L....................................... 9”W x 66-1/2”L

Fence ...................................................................4”W x 38-1/2”L....................................... 4”W x 38-1/2”L

Knife Size .................................................. 8”L x 11/16”W x 1/8”T......................... 0.59”L x 0.59”W x 0.10T

Fence Tilt ................................................................... 45ºL, 45ºR ............................................ 45ºL, 45ºR

Positive Stops...................................................... 45ºL, 90º, 45ºR...................................... 45ºL, 90º, 45ºR

Motor ................................................ 2HP, 1Ph, 60Hz, 230V only.................... 2HP, 1Ph, 60Hz, 230V only

Net Weight, Jointer and Stand (approx.) ......................... 400 lbs.................................................... 411 lbs

Shipping Weight, Jointer and Stand ................................ 495 lbs.................................................... 505 lbs

The above specifications were current at the time this manual was published, but because of our policy of

continuous improvement, Walter Meier (Manufacturing) Inc., reserves the right to change specifications at

any time and without prior notice, without incurring obligations.

1. Handwheel for Outfeed Table 8. On/Off Switch (Pedestal style on JJ-8HH)

2. Outfeed Table 9. Rabbeting Ledge

3. Fence 10. Table Lock Knob

4. Fence Adjustment Handle 11. Fence Tilt Lock Handle

5. Cutter Guard 12. Fence Control Handle

6. Infeed Table 13. Belt Guard

7. Handwheel for Infeed Table 14. Dust Chute