Use and Care Manual

Canister Kit Assembl

If you purchased Model DC-650CK Dust Collector, this

section describes the assembly and installation of the

contents of the Canister Kit (SN 708737C).

Canister Filter Installation

Referring to Figure 6:

1. Place the canister filter so that it fits snugly over

the housing and tighten the four knobs (A).

2. Mount handle (B) to the arm (C) with an M8 flat

washer (D), M8 lock washer (E) and M8 hex nut (F).

3. Thread an M10 hex nut (G) onto the threaded rod

found on top of the canister filter followed by an

M10 lock washer (H), and M10 flat washer (I).

4. Mount the arm (C) to the threaded rod on top of

canister with one M10 flat washer (J), and M10

hex nut (K).

Collector Bag Installation

1. Place the snap ring (K, Fig. 7) over the top of

plastic bag (L, Fig. 7) and fold over the bag

approximately three inches.

2. Insert the snap ring of the collector bag into the

bottom of the housing at an angle, see Figure 8.

3. Pull down on the ring to make sure it “seats” in the

housing.

Note: Make sure the snap ring “snaps” into place

in the housing, and also that the plastic bag hangs

down approximately 3” so that there are no air

leaks.

Figure 6

Figure 7

Figure 8