Use and Care Manual

7
Unpacking
The table below lists the shipping cartons that are
included with the models of the DC-650 Dust
Collector.
1. Locate your particular model and verify that you
have received the all the correct cartons.
2. Check contents of each carton against the ship-
ping content listings on this and the following
page.
3. Report any damage to your distributor.
4. Do not discard any shipping material until after
the dust collector has been assembled and is
running properly.
Base Unit (Stock No 708642)
Filter Bag Kit
(Stock No 708642B)
Filter Bag Kit
(Stock No 708642MF)
Canister Filter Kit
(Stock No 708737C)
DC-650BK x x
DC-650CK x x
DC-650MK x x
Table – DC-650 Dust Collector cartons
Shipping Contents
Bag Filter Kits
(Stock No. 708642B):
1 – Collector Bag
1 – Filter Bag
1 – Retaining Strap
1 – Filter Bag Support Rod
1 – Hardware Bag (Stock No DC650-FHP)
1 – M6 Hex Nut
1 – M6 Flat Washer
1 – M6 Lock Washer
(Stock No. 708642MF):
1 – Collector Bag
1 – Snap Ring
1 – Filter Bag
1 – Retaining Strap
1 – Filter Bag Support Rod
1 – Hardware Bag (Stock No DC650-FHP)
1 – M6 Hex Nut
1 – M6 Flat Washer
1 – M6 Lock Washer
Shipping Contents (cont)
Base Unit
(Stock No 708642)
1 – Base
1 – Impeller Housing/Motor Assembly
1 – Motor Cooling Fan
2 – Fixed Casters
2 – Pivoting Casters
1 – Support Cylinder
1 – Owner's Manual
1 – Warranty Card
1 – Hardware Bag (Stock No DC650-HP)
4 – M6 x 12 Cap Screws
4 – M6 Lock Washers
4 – M6 Flat Washers
2 – 3/8"-16 Acorn Nuts
2 – 3/8" Hex Nuts
4 – M10 Flat Washers
4 – M8 x 12 Cap Screws
4 – M8 Flat Washers
1 – 5mm Hex Wrench
Canister Filter Kit
(Stock No 708737C)
1 – Canister Filter
1 – Handle
1 – Arm
5 – Collector Bags
1 – Snap Ring
1 – Hardware Bag (Stock No DC650-CHP)
2 – M10 Hex Nuts
2 – M10 Flat Washers
1 – M10 Lock Washer
4 – Knobs
1 – M8 Hex Nut
1 – M8 Flat Washer
1 – M8 Lock Washer
Tools Required for Assembly
2 14mm Wrenches or Sockets
2 13mm Wrenches or Sockets
2 10mm Wrench or Socket
1 17mm Wrench (for Canister Kit assembly
1 06mm Hex Wrench