Use and Care Manual

Filter Bag Kit Assembl

If you purchased Model DC-650BK or DC-650MK Dust

Collector, this section describes the assembly and

installation of the contents of the Filter Bag Kit

(SN 708642B and 708642MF).

Filter Bag Installation

Referring to Figure 4:

1. Thread an M6 hex nut onto the filter bag support

rod (B), followed by an M6 flat washer and M6 lock

washer (A). Thread the support rod (B) into the

motor/fan housing and tighten nut against the

housing using a 10 wrench.

2. Place the retaining strap (C) through the loops on

the filter bag and hang the filter bag from the hook.

3. Secure bag to housing with retaining strap.

Note: The retainer strap should be tight enough to

provide a good seal.

Collector Bag Installation (30 Micron Kit)

1. Insert the snap ring of collector bag into the bottom

of housing at an angle (Figure 5).

2. Pull down on the ring and bag to make sure it

“seats” in the housing.

Collector Bag Installation (5 Micron Kit)

The 5-Micron Filter Bag Kit includes clear plastic

collector bags. Refer to Figures 7 and 8 on the next

page, along with the accompanying instructions, to

install these.

After completing the filter bag and collector bag

installation, proceed to Electrical Connections.

Figure 4

Figure 5