User Manual
Table Of Contents
- DC-1100VX Series Dust Collectors
- Warranty and Service
- Table of Contents
- Warnings
- Specifications
- Unpacking
- Shipping Content
- Base Unit Assembly
- Filter Bag Kit Assembly
- Canister Kit Assembly
- Electrical Connections
- Turning the Machine On & Off
- Dust Collector RF Remote Power Control (Optional)
- Maintenance
- Parts
- Wiring Diagram – DC-1100VX Dust Collectors
11
Filter Bag Kit Assembl
y
If you purchased a DC-1100VX-BK, or DC-1100VX-5M
Dust Collector, this section describes the assembly and
installation of the contents of the Filter Bag Kit (SN
708636F or 708636MF).
Filter Bag Installation
Referring to Figure 8:
1. Place the hanger (A) on the hanger bracket (B).
2. Slide the filter bag loop (C) over the hanger hook.
3. Feed the retainer strap (D) through the loops on the
filter bag (E) and fasten to the collector housing (F).
Collector Bag Installation (30 Micron Kit)
Referring to Figure 9:
4. Insert the ring of the collector bag (A) at an angle into
the housing (B) through the opening at the bottom.
Pull down on the bag to make sure it “seats” in the
housing.
5. Position the plastic window in front so that you can
easily see when the collector bag is full.
Collector Bag Installation (5 Micron Kit)
The 5-Micron Filter Bag Kit includes clear plastic collector
bags. Refer to Figures 11 and 12 on the next page, along
with the accompanying instructions, to install these.
After completing the filter bag and collector bag
installation, proceed to Electrical Connections.
Figure 8
Figure 9