Use and Care Manual

13. Attach the upper blade guide bracket to bottom of new, longer guide post.
14. Fasten the new blade guard assembly (Item #7-11, Fig. 1) to the upper blade guide bracket. Note:
Always adjust the blade guard assembly to cover the blade completely whenever the guide post
height is changed.
15. Install the new blade; tension and track the blade; adjust both blade guides; close both blade wheel
covers. Install the table pin and the table-insert and connect the bandsaw to the power source. See
bandsaw operator's manual for full details regarding these adjustments.
Index No. Part No. Description Size Qty
1 ................. 199188W ..................... Riser Block ................................................................... ........................................ 1
2 ................. 173106W ..................... Blade Guard ................................................................. ........................................ 1
3 ................. SH608403 ................... Hex Cap Screw ............................................................ 5/8-11 x 8-1/2 .................. 1
4 ................. TS-0680081 ................ Flat Washer .................................................................. 5/8 ................................... 1
5 ................. TS-0561071 ................ Nut ............................................................................... 5/8-11 .............................. 1
6 ................. 150907 ........................ Guide Post ................................................................... 3/4" Diameter .................. 1
7 ................. 199102 ........................ Upper Wheel Blade Guard (right) ................................. ........................................ 1
8 ................. 199199 ........................ Upper Wheel Blade Guard (left) ................................... ........................................ 1
9 ................. SC089400 ................... Carriage Bolt ................................................................ M8 x 16 ........................... 1
10 ............... TS-1550061 ................ Washer......................................................................... M8 ................................... 1
11 ............... TS-154306 .................. Wing Nut ...................................................................... M8 ................................... 1
12 ............... 199196 ........................ Saw Blade.............................................3/8” x 0.020” x 105-1/2” (6TPI) ................ 1
13 ............... 150031 ........................ Pin ................................................................................ ........................................ 1
Note: If used with Carter Band Saw Guides (708121), you must order #199102C to replace index #7.
Figure 1
Figure 2
2