Use and Care Manual

6. Install the housing (A, Fig. 5) to two support legs (B,

Fig. 5) using four M8 x 16 hex cap bolts, eight M8 flat

washers, and four M8 hex nuts (C, Fig. 5). Be sure

hose opening faces fan housing.

Note: For models DC-1200VX-BK1 or DC-

1200VX-BK3 only – Before attaching third support

bracket, place the hanger bracket (D, Fig.5)

between the support bracket and the housing.

7. Tighten all nuts and bolts at this time with a 13mm

wrench.

Cone Assembly

Referring to Figure 6:

8. Mount the cone support bracket (E) to the housing

with four M6x12 hex cap screws (F), and tighten from

beneath with four M6 hex nuts (G).

9. Install the cone (H) from beneath using the M8x16

hex cap screw (J), M8 flat washer (K), and M8 hex

nut (L), and tighten.

Hose

Referring to Figure 7:

10. Attach the hose (B) between the fan housing (A) and

the impeller housing (D) with two clamps (C).

Tighten the clamps to secure the hose.

This completes the Base Unit assembly. If you purchased

the DC-1200VX-BK1 or DC-1200VX-BK3 Dust Collector

(filter bag version), continue on the following page. If you

purchased the DC-1200VX-CK1 or DC-1200VX-CK3

Dust Collector (canister filter version), proceed to

Canister Kit Assembly section on page 12.

Figure 5

Figure 6

Figure 7