Use and Care Manual

Filter Bag Kit Assembl

If you purchased Model DC-1200VX-BK1 or DC-1200VX-

BK3 Dust Collector, this section describes the assembly

and installation of the contents of the 30 Micron Filter Bag

Kit (SN 708636F). These instructions also apply to the

optional 5 Micron Filter Bag Kit (SN 708636MF).

Filter Bag Installation

Referring to Figure 8:

1. Place the hanger (A) on the hanger bracket (B).

2. Slide the filter bag loop (C) over the hanger hook.

3. Feed the retainer strap (D) through the loops on the

filter bag (E) and fasten to the collector housing (F).

Collector Bag Installation

Referring to Figure 9:

4. Insert the ring of the collector bag (A) at an angle into

the housing (B) through the opening at the bottom.

Pull down on the bag to make sure it “seats” in the

housing.

5. Position the plastic window in front so that you can

easily see when the collector bag is full.

After completing the filter bag and collector bag

installation, proceed to Electrical Connections.

Figure 8

Figure 9