Use and Care Manual

1.0 IMPORTANT SAFETY
INSTRUCTIONS
WARNING – To reduce risk of injury:
1. Read and understand entire owner's manual
before attempting assembly or operation.
2. Read and understand the warnings posted on
the machine and in this manual. Failure to
comply with all of these warnings may cause
serious injury.
3. Replace warning labels if they become
obscured or removed.
4. This band saw is designed and intended for use
by properly trained and experienced personnel
only. If you are not familiar with the proper and
safe operation of a band saw, do not use until
proper training and knowledge have been
obtained.
5. Do not use this band saw for other than its
intended use. If used for other purposes, JET
disclaims any real or implied warranty and holds
itself harmless from any injury that may result
from that use.
6. Always wear approved safety glasses/face
shield while using this machine. (Everyday
eyeglasses only have impact resistant lenses;
they are not safety glasses.)
7. Before operating band saw, remove tie, rings,
watches and other jewelry, and roll sleeves up
past the elbows. Remove all loose clothing and
confine long hair. Non-slip footwear or anti-skid
floor strips are recommended. Do not wear
gloves.
8. Keep work area clean. Cluttered areas and
benches invite accidents.
9. Use proper extension cord. Make sure your
extension cord is in good condition. When using
an extension cord, be sure to use one heavy
enough to carry the current your product will
draw. An undersized cord will cause a drop in
line voltage resulting in loss of power and
overheating. Table 1 shows the correct size to
use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier
gage. The smaller the gage number, the
heavier the cord.
10. Secure work. Use clamps or a vise to hold work
when practical. It’s safer than using your hand
and it frees both hands to operate tool.
11. Disconnect tools before servicing; when
changing accessories, such as blade, bits,
cutters and the like.
12. Direction of feed: Feed work into a blade or
cutter against the direction of rotation of the
blade or cutter only.
13. Maintain proper adjustment of blade tension,
blade guides, and thrust bearings.
14. Adjust upper blade guides to just clear
workpiece (approximately 1/8”).
15. Make sure blade tension, tracking and blade
guides are all properly adjusted.
16. Make relief cuts where possible, when cutting
curved stock.
17. When feeding small work pieces into blade,
always use push stick, fixture, or similar device
to keep hands at a safe distance.
18. Hold stock firmly and flat against table.
19. Wear ear protectors (plugs or muffs) during
extended periods of operation.
20. Some dust created by power sanding, sawing,
grinding, drilling and other construction
activities contain chemicals known to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead based paint.
• Crystalline silica from bricks, cement and
other masonry products.
• Arsenic and chromium from chemically
treated lumber.
Your risk of exposure varies, depending on how
often you do this type of work. To reduce your
exposure to these chemicals, work in a well-
ventilated area and work with approved safety
equipment, such as face or dust masks that are
specifically designed to filter out microscopic
particles.
21. Do not operate this machine while tired or under
the influence of drugs, alcohol or any
medication.
22. Make certain switch is in OFF position before
connecting machine to power supply.
23. Make certain machine is properly grounded.
24. Do not back stock out of blade while blade is
running.
25. Do not remove jammed cutoff pieces until blade
has stopped.
26. Remove adjusting keys and wrenches. Form a
habit of checking to see that keys and adjusting
wrenches are removed from the machine
before turning it on.