Full Product Manual
Table Of Contents
- 16-speed Woodworking Drill Press
- 1.0 Warranty and Service
- 2.0 Table of contents
- 3.0 Safety warnings
- 4.0 About this manual
- 5.0 Specifications
- 6.0 Setup and assembly
- 7.0 Electrical connections
- 8.0 Adjustments
- 9.0 Operating controls
- 10.0 Operation
- 11.0 User-maintenance
- 12.0 Speed chart
- 13.0 Troubleshooting the JDP-17
- 14.0 Replacement Parts
- 15.0 Electrical Connections – JDP-17 Drill Press
7
Base and Column:
Base size............................................................................................................ 20” L x 13” W (507 x 328 mm)
Base working surface ............................................................................... 8-1/2” L x 10-1/2” W (217 x 271 mm)
Base slots (2) ........................................................................................................ 5/8” W x 7” L (15 x 178 mm)
Distance between base slots (centers) .................................................................................... 5-1/8” (130 mm)
Column diameter ...................................................................................................................... 3-5/32” (80 mm)
Dimensions and Weights:
Overall dimensions, assembled ........................................... 28-1/2” L x 19” W x 66” H (723 x 483 x 1679 mm)
Shipping dimensions ............................................... 58” L x 24-7/16” W x 12-13/16” H (1475 x 620 x 325 mm)
Net weight (approximate) .............................................................................................................. 187 lb (85kg)
Shipping weight (approximate)...................................................................................................... 198 lb (90kg)
L = length; W = width; H = height
1
Subject to local and national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
3
Swing is twice the distance from column to spindle center (i.e., the maximum diameter of workpiece that can be
drilled to its center).
5.1 Base mounting holes for JDP-17
Figure 1: Base mounting holes
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.