Use and Care Manual

10
Figure 7
9. Place stop collar (G, Figure 8) onto column
and slide it down over top end of rack. Orient
the stop collar so that chuck key holder (H) is
in desired position around the column.
10. Tighten set screw (J) with a 4mm hex key.
11. Push chuck key into holder (inset, Figure 8)
Figure 8
12. Slide table elevating handle (HP4, Figure 9)
onto protruding shaft of worm. Make sure the
set screw in the handle aligns with the flat on
the worm shaft.
13. Tighten set screw (K) in table elevating handle
with 4mm hex key.
14. Mount column locking handle (HP3, Figure 9)
to rear of table bracket. The quickest way to
install this is to remove the handle by
unscrewing the screw with its spring (L). Insert
the bolt (N) into the table bracket hole, then
reinstall handle (M), spring and screw (L).
Note: The locking handle (HP3) is adjustable.
To reposition, pull out on the handle and rotate
it, then release it, making sure it reseats itself
on the bolt head.
Figure 9
The head assembly is
heavy! To avoid injury and/or damage to
equipment, lift the head onto the column
only with additional assistance!
15. With the aid of a second person, carefully lift
the head assembly and place it onto the
column. Slide head down as far as it will go.
Rotate head assembly until the sides of the
belt cover are parallel with the sides of the
base.
16. Tighten the two set screws (O, Figure 10) with
a 5mm hex key until they are snug.
Figure 10
17. Install three downfeed handles (HP5, Figure
11) into hub by screwing them in completely. A
flat is provided on each handle for a 9mm
wrench or pliers to help tighten if needed.
Figure 11