Use and Care Manual

ManualsBrandsJET ManualsDrill PressesJDP-17 17 in. 3/4 HP Drill Press

5.0 Specifications

Model number ............................................................................................................................................. JDP-17

Stock number .............................................................................................................................................. 716300

Motor and electricals:

Motor type ....................................................................... totally enclosed fan cooled, induction, capacitor start

Horsepower ............................................................................................................................................. 3/4 HP

Phase ........................................................................................................................................................ single

Voltage ............................................................................................................................................... 115V only

Cycle .......................................................................................................................................................... 60Hz

Listed FLA (full load amps) ........................................................................................................................... 9 A

Starting amps .............................................................................................................................................. 18 A

Running amps (no load) ................................................................................................................................ 3 A

Start capacitor .......................................................................................................................... 150μF, 125VAC

Run capacitor ............................................................................................................................. 40μF, 250VAC

Power transfer ............................................................................................................................... 2 poly v-belts

On/off switch ...................................................................................... push button with safety key, paddle stop

Motor speed ...................................................................................................................................... 1720 RPM

Power cord .................................................................................................................... 16 AWG, 6 ft. (183 cm)

Power plug installed ....................................................................................................... 115V, 15A with ground

Recommended circuit size

........................................................................................................................ 15 A

Sound emission

................................................................................................ 80dB at 39” (1m) without load

Laser system .......................................................................................................................................... Class II

Head and Capacities:

Swing

.................................................................................................................................... 16-7/8” (430mm)

Chuck style and shank capacity .......................................................................................... keyed, 5/8” (16mm)

Chuck arbor taper ......................................................................................................................... JT-3 to MT-2

Spindle taper .............................................................................................................................................. MT-2

Spindle travel, maximum ................................................................................................................ 5” (127 mm)

Spindle travel per one revolution of handle .................................................................................... 5” (127 mm)

Quill diameter .............................................................................................................................. 2.05” (52 mm)

Number of spindle speeds ............................................................................................................................. 16

Maximum no-load speed range.............................................................................................. 210 to 3500 RPM

Maximum spindle to table distance .............................................................................................. 30” (763 mm)

Maximum spindle to base distance ...................................................................................... 46-1/2” (1180 mm)

Maximum chuck to table distance .......................................................................................... 25-1/4” (640 mm)

Maximum chuck to base distance ........................................................................................ 42-1/2” (1080 mm)

Work lamp .................................................................................................................... integrated, pivoting LED

Depth stop type ...................................................................................................................................... internal

Materials:

Head..................................................................................................................................................... cast iron

Table ......................................................................................................................... precision-ground cast iron

Table insert ................................................................................................................................................ MDF

Column ....................................................................................................................................................... steel

Base ..................................................................................................................................................... cast iron

Table:

Table size ........................................................................................................... 14” L x 19” W (356 x 483 mm)

Table slots (4) .................................................................................................... 3-1/8”L x 5/8” W (79 x 15 mm)

Table T-slots (2) ................................................................................................... 1/2” W x 5/8” D (13 x 15 mm)

Distance between T-slots (centers)........................................................................................ 10-5/8” (270 mm)

Table tilt.................................................................................................................................... 90 deg. L and R

Table rotation around column .............................................................................................................. 360 deg.

Table elevating system ...................................................................................................... worm gear with rack

Table insert ........................................................................................................... 3-3/4” x 3-3/4” (95 x 95 mm)

Recommended maximum weight on table .................................................................................... 66 lb. (30 kg)