Instruction Manual

4
Operation
CAUTION: If the optional casters are used, make
sure they are locked in place.
To tilt table:
1. Pull out left and right handles and rotate them 90-
degrees to keep them disengaged.
2. Begin tilting front edge of table downward until it
just clears the handle pins, then turn handles 90-
degrees and allow them to slide back in.
3. Continue to tilt table slowly, while helping
stabilize the machine(s), until table passes the
beveled pins at the rear and snaps into level
position.
When machines are
mounted to table, tilt table slowly and help
stabilize the machines throughout the tilt
process. Do not allow the table to swing
uncontrollably. Failure to comply may cause
personal injury and/or unnecessary stress
upon stand components.
Machine selection
The stand will accept most bench top machines up to
load capacity and within the table size range (see
specifications). Secure the machine to the table with
appropriate fasteners (not provided). Make sure
machine(s) are securely fastened before attempting to
tilt the table.
Position of machines upon the table is user’s choice;
however, consideration should always be given to the
machines’ center of balance and weight distribution.
Ideally, they are centered upon the table. But the
design of some machines may require them to be
shifted off center for optimum position and/or easier
tilting to the down position.
(machines and user-made shelf not provided)
Specifications for JET Flip-Top Stand
Stock number
728200
Table size (D x W)
20 x 25 in. (508 x 635 mm)
Height range
29 to 34 in. (736.6 to 863.6 mm)
Height adjustment
5.10 in. (130 mm)
Load capacity
300 lb. (136 kg)
Table material
MDF/Vinyl
Assembled weight
45 lb. (20 kg)
Shipping weight
49 lb. (22 kg)
The 728200 Flip-Top Stand will accommodate most bench top machines, including the following models:
Brand
Model
Stock No.
Notes
JET
13” Planer
722130
JET
8” Jointer/Planer
707400
JET
8” Grinder
726101
JET
1020 Drum Sander
723510
JET
9” Belt/Disc Sander
708595
JET
Spindle Sander 5”
708404
JET
18” Scroll Saw
727300B
JET
22” Scroll Saw
727200B
JET
10” Miter Saw
707210
Secure miter arm before tilting underneath.
JET
12” Miter Saw
707212
Secure miter arm before tilting underneath.
JET
JET Mortiser
708580
Remove handle if needed before tilting underneath.
Powermatic
PM Mortiser
1791310
Remove handle if needed before tilting underneath.
JET
10” Band saw
714400
JET
12” Drill Press
716000
JET
15” Drill Press
716200
Powermatic
PM1250 Air Filtration
1791250