Use and Care Manual

5
4.0 Specifications
Table 1
Model number
JB-10P JB-10R
Stock number 751005 751010
Motor and Electricals
Motor type DC servo, brushless, fan cooled
Horsepower 1HP (728 W)
Motor phase single
Motor voltage 115 V
Cycle 60/50 Hz
Listed FLA (full load amps) 10 A
Motor speed variable, 2000-5000 RPM variable, 2000-6000 RPM
PC board 310V DC output, 115VAC input
Power transfer Direct drive
On/off switch Magnetic switch, with removable safety key
Power cord and plug ST-201 3x14AWG 300V, 9 ft., 15A plug
Recommended circuit size
1
15 A
Sound emission without load
2
70dB
Capacities
Chamfer angle range 15° to 45°
Maximum chamfer width 3/8 in. (9.5 mm) at 45°
Guide plate adjustment stops 15°, 30°, 45°
Number of blade inserts 5 (indexable)
Guide plate length 9 in. (230 mm)
Minimum workpiece thickness 1/8 in. (3 mm)
Main materials
Motor housing and end shields Aluminum/sheet metal aluminum
Blade inserts Carbide steel
Guide plates Steel
Handles Polymer, rubber Polymer
General Dimensions
Overall dimensions L x W x H (approx.) 370 x 230 x 230 mm (14.6 x 239 x 9 in.)
Shipping dimensions L x W x H (approx.) 400 x 280 x 300 mm (15.7 x 11 x 11.8 in.)
Weights
Net weight (approx.) 9.3 kg (20.46 lbs) 8.3 kg (18.26 lbs)
Shipping weight (approx.) 10 kg (22 lbs) 9 kg (19.8 lbs)
1
subject to local/national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, D = depth
n/a = not applicable
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.