Use and Care Manual

4
Specifications
Model Number .................................................................... SR-2024M .................................................. SR-2236M
Stock Number ......................................................................... 756020 ....................................................... 756026
Capacity (mild steel) ................................................................ 20.......................................................... 22
Maximum Forming Length ......................................................24”......................................................... 36”
Number of Rolls ................................................................................ 3 ................................................................. 3
Diameter of Rolls .............................................................................. 2” ................................................................ 2”
Minimum Forming Radius ........................................................ 1”........................................................... 1”
Wire Grooves ..................................................... 3/16” 1/4", 5/16”..................................... 3/16” 1/4", 5/16”
Overall Dimensions, assembled (LxWxH) ..............
50” x 14” x 14”......................................... 62” x 14” x 14”
Overall Dimensions, shipping (LxWxH) .............
36” x 16” x 18-1/2”............................. 47-1/4” x 16-1/4” x 18”
Net Weight ................................................................................ 172 lb ......................................................... 212 lb
Shipping Weight ........................................................................ 216 lb ......................................................... 256 lb
Stand (Optional Accessory) .................................................... 754024 ....................................................... 754036
Dimensions (LxWxH) .............................................. 30” x 14” x 28” ............................................ 42” x 14” x 28”
Net Weight ............................................................................. 35 lb ........................................................... 51 lb
Uncrating and Clean-Up
1. Remove the crate from around the machine.
2. Carefully clean all rust protected surfaces with
a mild solvent or kerosene and a soft rag. Do
not use lacquer thinner, paint thinner, or
gasoline. These will damage painted surfaces.
3. Coat all machined surfaces with a light coat of
oil to inhibit rust.
4. Remove the bolts holding the machine to the
skid.
5. Carefully move the machine to a well lighted
area on a solid, level work bench, and secure
to the bench with lag screws or bolts.
6. Machine location must allow access to all
sides.
Front Rolls
The (#) in the text refers to the breakdown.
1. The upper and lower rolls #23 & #24 carry the
material through as the crank handle #33 is
turned in a clockwise direction.
2. The lower roll adjustment knobs #12 are used
to move the lower roll #24 up and down for
different gauge material.
3. The gap between the two front rolls should be
equal at both ends.
Rear Roll
1. The rear roll #25 can be adjusted to control the
radius by turning adjustment knobs #13.
2. The gap between the rear roll and the two front
rolls should be equal at both ends of the roll to
assure an equal radius at both ends of the
material.
Releasing the Material
1. Once the material has been rolled release the
material from the roll by lifting handle #29.
Move the handle bracket out of the way.
2. Lift the upper roll #23 by moving lever #3 to
the right so that the material can be removed.
Rolling Wires
There are three wire grooves in the lower and rear
rolls that will accommodate a 3/16”, 1/4", and 5/16”
wire.
Lubrication
The machine must be lubricated every day of
service with a few drops of oil. An oil pinhole is
located at both ends of the lower roll #24, and rear
roll #25. The upper roll #23 has two oil pinholes on
the left side. The right side can be lubed by
opening the handle #29, and lightly oiling the end
of the upper roll shaft.
Every thirty days of operation grease the gears by
removing the outer hex nut #7, and gear cover #18.
Lightly oil the rolls when not in use to prevent rust.