Operating Instructions and Parts Manual 24-inch Pneumatic Planishing Hammer Model PH-24T JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
Warranty and Service JET® warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
Table of Contents Warranty and Service .............................................................................................................................. 2 Table of Contents .................................................................................................................................... 3 Introduction .............................................................................................................................................
1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they become obscured or removed. 4. This planishing hammer is designed and intended for use by properly trained and experienced personnel only.
20. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious injury. 21. Do not overreach. Keep proper footing and balance at all times. 22. Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job better and more safely. 23. Use recommended accessories; improper accessories may be hazardous. 24.
Specifications for PH-24T Planishing Hammer Model .......................................................................................................................................................... PH-24T Stock Number ............................................................................................................................................. 756121 Electrical Power: Incoming Power .......................................................................................................
Features and Terminology Figure 1 - Features 7
Unpacking, Mounting and Assembly Operation 1. With the help of an assistant, carefully uncrate the planishing hammer. A tab is welded to the top tube if you choose to use a hoist to set up the machine. Keep hands clear of hammer and anvil area at all times! Failure to comply may cause serious injury! Referring to Figure 3: 2. Determine the most suitable location for your planishing hammer based on the planned usage of the machine. Larger workpieces require a larger space around the planishing hammer.
To remove the entire driver from the hammer barrel, push the tab on the air hammer housing and pull down on the driver. To reinstall the hammer drive, orient the notch toward the general direction of the tab, and push driver upward while still pushing back on the tab. When the driver is properly inserted, the tab will snap back into place. Make sure driver and dies are properly inserted before operating machine. Figure 4 6. Plug the planishing hammer into the power supply. 7.
Assembly Drawing for PH-24T Planishing Hammer 10
Ordering Replacement Parts To order parts or reach our service department, call 1-800-274-6848 Monday through Friday (see our website for business hours, www.jettools.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately. Parts List for PH-24T Planishing Hammer Index No. Part No. Description Size Qty 1 ................ PH24T-1G ................. Frame ....................................................................
Index No. Part No. Description Size Qty 25 .............. PH24-25 .................... Air Hose ................................................................... PVC Ø12x8 mm ............ 1 26 .............. PH24-26 .................... Foot Control ............................................................. ...................................... 1 27 .............. PH24-27 .................... Cable Protector ........................................................ Ø16 ............................
