Product Manual

7
Assembly
Never connect the machine
to the power source until assembly is
completed. Failure to comply may result in
serious injury!
1. Screw the handle (A, Fig. 2) into the pinion
shaft (B, Fig. 2).
2. Tighten the handle. The handle has a notch
(C, Fig. 2) to accommodate a wrench.
3. Use the handle to raise the machine head to
the up position. The handle is spring loaded
and can be repositioned by pulling the
handle away from the machine, and turned
to the desired angle.
4. With the head in the up position press the
hydraulic cylinder onto the two fittings. The
upper fitting (D, Fig.2) is located on the
head. The lower fitting (E, Fig.2) is on the
column.
5. Attach the table to the base using two
screws (A, Fig.3).
6. Insert bar of fence assembly (B, Fig.3)
through the hole in the column. Use the
fence-locking handle (C, Fig.3) to adjust
fence assembly.
7. Attach the hold down (D, Fig.3) to the
vertical post using locking handle (E, Fig.3).
Installing
Make sure the Mortising
Machine is attached to a firm and stable support
surface.
This machine must be fastened to a supporting
surface to prevent it from tipping during
operation. Four holes (A, Fig. 4) in the base are
supplied for this purpose.
Figure 2
Figure 3