Product Manual

8
Adjustments
On-Off Switch
The switch (A, Fig. 5) has a switch key that,
when pulled out, allows the switch to be locked
in the off position.
Handle Adjustment
The handle can be adjusted for leverage and
comfort. Pulling the spring loaded handle (A,
Fig.6) away from the head and turning allows
you to change the position of the handle.
Fence Adjustment
The fence can be moved in and out by
loosening the locking handle (B, Fig.4) on the
column.
Hold Down Adjustment
The hold down (C, Fig.4) should be adjusted so
it just touches the top of the workpiece and
allows the workpiece to slide left or right. The
hold down can also be taken off and turned over
for a thicker workpiece. To adjust the hold down,
loosen the locking handle (D, Fig.4).
Depth Stop Rod Adjustment
The depth stop rod (B, Fig. 5) is provided to limit
the depth of the chisel cut. Adjust the depth stop
rod using the locking handle (C, Fig.5). Lower
the head until the bottom of the chisel is at the
required depth. Lower the depth stop rod until it
is at rest against the base.
180° Head Rotation
Removing the three hex socket cap screws at
the base will enable you to rotate the head and
column 180°. Doing this will let the user mortise
taller items.
Chuck Key Holder
The chuck key holder is located on the left side
of the head.
Figure 4
Figure 5
Figure 6