Product Manual

8
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
5.0 Setup and assembly
5.1 Unpacking and cleanup
Remove all contents from shipping carton, and
remove accessories from drawer inside stand.
Compare parts to the contents list in this manual. If
shipping damage or any part shortages are
identified, contact your distributor. Do not discard
carton or packing material until dust collector is
assembled and running satisfactorily.
5.2 Shipping contents
Carton contents (see Figure 2)
1 Grinder stand
2 Water trays (L and R)
1 Inlet adaptor assembly
4 Foot pads
1 Open end wrench 10/12 mm
5.3 Tools required for assembly:
10/12mm wrench – provided
5.4 Assembly
1. Install foot pads beneath corners of stand.
Rotate pads to adjust height at each corner until
stand is level.
2. Install inlet adaptor onto dust port and secure
with screw (A, Figure 3).
Inlet adaptor should be
installed before plugging in or operating
dust collector.
3. Place water trays (left and right version) into the
recesses on front of stand.
Figure 3
5.5 Mounting a tool
Position tool, such as grinder or sander (not
provided) atop stand and secure with fasteners
through the hole/slot pattern. Connect 3-inch dust
hose (optional accessory) to inlet adaptor port and
tool, and secure with hose clamps.
IMPORTANT: An inlet port that is not used during
operation should be capped. An open port will
diminish the efficiency of the dust collector and may
present a safety hazard.
5.6 Adaptor plate (optional)
An adaptor plate kit (optional accessory, p/n
#414830) is available, and will accept tools with
different mounting hole patterns.
To install adaptor plate kit:
1. Install left and right supports (A, Figure 13) to
stand with 1/4 in. screws.
2. Install adaptor plate (B) to supports with 1/4 in.
screws, and secure to top of stand with 5/16 in.
screws.
3. Mount tool to adaptor plate, and secure with
appropriate fasteners.
Table 1 shows JET machines that will mount to
either the stand or the adaptor plate.
Figure 4
JET Tool stock no. mounts to:
IBG-8 Grinder* 578008 Stand
IBG-10 Grinder* 578010 Stand
JBG-6A Grinder 577101 Stand
JBG-8A Grinder 577102 Stand
JBG-10A Grinder 577103 Stand
*Connect IBG Bench grinders to stand using
414811 hose and 414825 reducer.
Table 1