Product Manual

17
Cutterhead Drive Belt Replacement
4. Loosen four motor mount screws (L). Lift the
motor and rest it in the horizontal slot side of
the motor mount opening. This will create a
slack in the cutterhead drive belt (F).
5. Remove the cutterhead drive belt (F) from
around the cutterhead pulley (E) and motor
pulley (M).
6. If the feed-roller belt (K) is to be replaced,
continue. Otherwise proceed to step 10.
Feed-roller Belt Replacement
Note: If the feed-roller belt is to be replaced, steps
1–5 must be performed to remove the cutterhead
drive belt before the feed-roller belt can be
replaced.
7. Place the power feed handle (J) in the down
(off/disengaged) position, which provides belt
slack for the next step.
8. Remove the feed-roller belt (G) from around
the feed-roller pulley (K) and motor pulley (M).
9. Loop the new belt around the smaller (inner)
motor pulley (M) and feed-roller pulley (K).
Note: The lower stretch of the feed-roller
pulley must be positioned between the belt-
brake plates (N).
Concluding Steps
10. Replace the cutterhead drive belt (F) by
looping it around the cutterhead pulley (E),
then the larger (outside) motor pulley (M)
11. Slide the motor so that the mounting screws
(L) rest back in the vertical slot openings, then
tighten the mounting screws.
12. Replace the lower back panel (P) and secure
with four button head socket screws (O).
13. Replace the upper back panel (D) and secure
with two button head socket screws (C).
14. Replace the jointer fence assembly (A) and
secure with two lock handle assemblies (B).