User Manual

15
10.6 Jointer table lock handle
adjustment
Refer to Figure 10 on page 12:
For best performance, the jointer table lock
handles (A
2
) should be approximately in the fully
down position when in the locked position. If
adjustment is required:
1. Disconnect machine from power source.
2. Unlock the lock handles (A
2
) and raise the
table to the upright position.
3. Loosen locking nut (C
2
) with an 18mm wrench.
4. Adjust the table locking shaft (C
1
) in
increments of 1/4 turns or less. Turn clockwise
to tighten the lock handle performance and
counterclockwise to loosen.
5. Tighten the locking nut (C
2
).
6. Test the locking function and repeat if neces-
sary.
10.7 Belt replacement
Disconnect machine from
power source before making any adjustments.
Failure to comply may cause serious injury.
Refer to Figure 14.
Preparation
To replace the cutterhead drive belt and/or the
planer feed-roller belt, the jointer fence assembly
and two back panels must first be removed as
described below. A 4mm hex wrench and two
13mm wrenches are required.
1. Remove the jointer fence assembly (A, Figure
14) by first loosening and removing two lock
handle assemblies (B).
2. Remove two button head socket screws (C)
and upper back panel (D).
3. Remove four button head socket screws (O)
and lower back panel (P).
Cutterhead Drive Belt Replacement
4. Loosen four motor mount screws (L). Lift the
motor and rest it in the horizontal slot side of
the motor mount opening. This will create a
slack in the cutterhead drive belt (F).
5. Remove the cutterhead drive belt (F) from
around the cutterhead pulley (E) and motor
pulley (M).
6. If the feed-roller belt (K) is to be replaced,
continue. Otherwise proceed to step 10.
Figure 14