User Manual

9
9.3 Control switch
Once a properly rated plug is connected, plug
power cord into outlet. Press the green on button
(A, Fig. 4) to start. Press the red off button
(B, Fig. 4) to stop.
9.4 Planer controls and adjustments
Refer to Figure 5:
Power Feed
Placing the planer power feed handle (D) in the up
position turns the planer power feed on (see
arrow). Placing the handle in the down position
turns the power feed off.
Table Lock
Turn the table lock (E) clockwise to lock the height
adjustment handwheel (F) and secure the planer
table (C) in its selected position. Turn the table
lock (E) counterclockwise to release and permit
table adjustment.
Table Height Adjustment
The planer table height is set as follows:
1. Unlock the table lock (E).
2. Rotate the height adjustment handwheel (F)
clockwise to raise the planer table (C),
counterclockwise to lower.
3. Lock the table lock (E).
Each revolution of the handwheel (F) results in a
5/32" up or down movement of the table (C). A
scale on the handwheel column indicates the
amount of handwheel rotation. A pointer (B)
indicates the table position relative to the
cutterhead on the scale (A) located on the side of
the cabinet.
9.5 Jointer controls and adjustments
Refer to Figure 6:
Outfeed Table Height Adjustment
Lock knob (C) and lifting handle (B) control the
height adjustment of the outfeed table (A).The
outfeed table is initially adjusted at the factory and
should not be repositioned except during certain
adjustments. These are described in sect. 10.1,
Table and Knife Adjustments.
Infeed Table Height Adjustment
Lock knob (D) and lifting handle (E) control the
height adjustment of the infeed table (F).
To adjust:
1. Loosen lock knob (D).
Figure 4
Figure 5
Figure 6