Product Manual

10
Adjustments
1. Knee Gib Adjustment (#53, page 18)
adjust gib screw (#18, page 18) below
wiper on the left side of the knee for proper
travel and excess play.
Note: when adjusting the gibs always start
with the knee. Adjust the saddle second,
and adjust the table last.
2. Saddle Gib Adjustment (#47, page 18)
adjust gib screw (#18, page 18) found on
the right side front of the carriage for proper
travel and excess play.
3. Table Gib Adjustment (#45, page 18)
adjust gib screw (#18, page 18) found on
the left side of the table toward the front of
the carriage for proper travel and excess
play.
4. Ram Ware Plate (#10, page 18) adjust two
set screws (#19, page 18) found on the
side of the ram for proper travel.
5. Head Alignment the scales on the ram
adapter and head rotation are guides only.
Close tolerance work will require the use of
a dial indicator to make sure the head is
90º to the table in the X axis.
6. Longitudinal and Crossfeed Adjustment
- if there is excessive backlash in the handle.
a) Loosen hex socket head screw (#27,
page 16).
b) Turn feed screw nut (#26 or #29, page
16) to remove play.
c) Tighten hex socket head screw.