Product Manual

4
Assembly
Note: The SLT-660F does not require any
assembly.
1. On the SLT-1650, attach the handle (A,
Figure 1) to the frame using two hex cap
screws, two lock washers, two flat washers.
Tighten with a 19mm wrench.
Note: The two pivoting casters can be
locked so that they do not rotate. Press foot
lever (B, Figure 1 for SLT-1650) down to
lock. Press foot lever (A, Figure 2 for SLT-
660F) down to lock.
2. Attach foot lever (A, Figure 3) to the lever
bracket (B, Figure 3) with one hex cap bolt,
one flat washer, one lock washer (C, Figure
3). Tighten with a 14mm wrench.
Keep hands and feet clear of
table and scissor lift openings while
lowering load. Failure to comply may cause
serious injury!
3. Pump the foot lever several cycles so that
the table is out of your way while attaching
the cable.
Note: Place a 2” x 4” board straight up and
down between the table and frame so that
the table cannot come down on you while
attaching the cable.
4. Route the cable (A, Figure 4) into the cable
nut (B, Figure 4). Run the cable through the
lowering mechanism (C, Figure 4) and pull
the cable tight. Tighten the hex nut (D,
Figure 4) using a 14mm wrench.
Note: You may have to turn the hex socket
cap screw to line up the hole. This will allow
the cable to pass through freely.
Figure 4
Figure 1
Figure 2
Figure 3