Product Manual

8
Note: Figures in this manual may or may not
exactly match the appearance of your machine.
7.0 Unpacking
7.1 Contents of Shipping Container
1 Band Saw
1 Table
1 Fence and Rail Assembly
1 Resaw Guide and Knob
1 Miter Gauge
1 Upper Chip Tray
1 Owner’s Manual
1 Warranty Card
1 Accessory Package Contains:
Hardware Bag
2 Knobs
1 Handle
1 10/12mm Wrench
2 Screws, 1/4-20x1/4” (Upper Chip Tray)
Fence Hardware Bag
4 Socket Head Cap Screws, 5/16x3/4”
4 Flat Washers, 5/16”
4 Lock Washers, 5/16”
Rail Hardware Bag
9 Hex Cap Screws, 1/4-20 x 5/8”
9 Flat Washers, 1/4”
9 Lock Washers, 1/4”
1. Remove the crate and packing material from
the band saw except for the transport skid on
the bottom.
2. Move the saw to its permanent working
location. The site should be dry, well lit, and
have enough room to handle long stock and
the service or adjustment of the machine from
any side.
3. Move the band saw off the skid.
4. Clean all rust protected surfaces with a mild
solvent or kerosene and a soft cloth. Do not
use lacquer thinner, paint thinner, or gasoline.
These will damage painted surfaces.
5. For greater stability, the band saw can be
secured to the floor with lag screws (not
provided) through the four holes in the base.
Tools Required for Assembly & Adjustments
1 10mm Open End Wrench (provided)
2 14mm Open End Wrenches (not provided)
1 Cross Point Screw Driver (not provided)
1 Combination Square (not provided)
1 6mm hex wrench (not provided)