User manual

Communication with the DUPLEX Receiver with aid of the JETIBOX
The JETIBOX can be connected to the receiver in two ways:
1. By direct connection JETIBOX <-> receiver
Plug the connector of the interconnecting cable (enclosed in the JETIBOX package) into the receptacle marked Impuls
+ - (positioned at the right side of the JETIBOX) and the other end into the receiver receptacle marked Ext. Connect the
current supply to the receiver (see current supply) or to the current supply receptacle of the JETIBOX.
2. By wireles connection JETIBOX <-> transmitter <-> receiver
In that case the JETIBOX must be connected to the transmitter. Switch on the transmitter and connect the current
supply of the receiver.
The display shows the text Tx and arrows to the right and down. You may enter the receiver menu by pushing the key R
(arrow right), the display shows the text Rx after that you enter the receiver menu by pushing key D (arrow down). The
display picture corresponds to the picture as shown in case of direct connection (see item 1).
Wireless connection with the receiver is possible in Normal mode only. If you would during wireless connection
change from Normal mode to Clone mode, the receiver would switch to monitoring mode and the JETIBOX would stop
to respond. In order to renew communication with the receiver the JETIBOX will have to be reconnected to the receiver
directly, see item 1. In case of using a receiver which has before been working in monitoring mode (Clone) in an other
model, do not forget to set it back to the original mode (Normal).
The JETIBOX can be disconnected only after the receiver has been also disconnected from its voltage supply. It is
anytime possible to follow up the condition of the receiver or to set up its parameters even during its operation in the
model, but this ought to be done very carefully. Setups should be carried out only if security of the model against
damage and of persons against injury is warranted. As an important safety measure an accidental motor start should
be prohibited by all means, removing the propeller from the model might be very helpful!
Communication with the Expander DUPLEX Ex by taking advantage of the JETIBOX (JB):
Plug the connector of the interconnecting cable (enclosed in the JETIBOX package) into the receptacle marked (Rx) at
the back of the expander and the other end into the receptacle of the receiver marked (Ext.). Connect the JETIBOX to
the transmitter module. Switch on the transmitter and connect the current supply to the receiver (see current supply).
In the JETIBOX display there appears the text Tx and by pushing key R (arrow right) twice you will select the item Mx.
By pushing key D (arrow down) will enter expander menu. The main menu (selection of the connected device Tx, Rx,
Mx) will be attained by holding down key U (arrow up) for a longer time).
Overview of Receiver Data Items
The introductory display shows the type of receiver. By pushing of key R (arrow down) more detailed data of receiver
and transmitter can be cued.
Pairing: by pushing the key U (arrow up) pairing of the receiver with the transmitter will be executed. Pairing of the
receiver should only be carried out when the JETIBOX is directly connected to the receiver.
EN
Receivers