User manual

- PPM Output mode: Direct– setup of the satellite receiver to the mode of
direct PPM signal generation, i. e. without changes in the receiver. With this
setup the PPM signal is generated in the same configuration as it was loaded
by the encoder into the transmitter module. Any claims for signal changes in
the receiver are set up in the main receiver R18.
- Signal Fault: Out Off–if the satellite receiver will not receive any signals
from the transmitter, there will be no PPM output signal generated at the RSat
output and the transmitter module will report this situation by an acoustical
signal (if the alarm for PPM signal loss in the R18 receiver is activated)
Setup of the receiver R18:
Menu Out Pin Set – SetInChannel Y18– select item PPM input, in that case you will be furtheron able to set up the
alarm for PPM signal loss at the input of SAT1 – PPM Alarm Code A.
We wish you sucessful flying with the products of:
JETI model s.r.o. Příbor, www.jetimodel.com
For receivers we grant a warranty of 24 months from the day of purchase under the assumption
that they have been operated in conformity with these instructions at recommended voltages
and that they were not damaged mechanically. Warranty and post warranty service is provided
by the manufacturer.
Wiring Example of the receiver R18:
Connection of receiver RSat to the input SAT1 of the receiver R18
The receiver RSat gets its current supply from receiver R18 and is paired with the transmitter module Tx. We
recommend not to exceed a connection cable length of 2 meters between the receivers R18 and Rsat.
Setup of receiver Rsat:
Menu Main Setting:
- Rx mode: Clone– setup of the satellite receiver to monitoring mode
EN
Receivers