User manual

Connection of the external buzzer and earphones:
An earphone or an additional external buzzer may be connected to
the module TU2. Connection to the module TU2 is carried out by
means of the gold plated pins as shown in the picture (polarity is of no
significance). The module TU2 is able to recognize the connection of
earphones and automatically disables the buzzer for generation of
telemetric alerts. Alerts concerning loss of range, low receiver are
generated into earphones as well as into the buzzer.
Assembly kit: Voice-1
1. Jack 3,5mm -
2. Ext. buzzer - accessory
Earphone connecting accessory
1
2
SWTU2
JETIBOX
Earphones Buzzer
PPM
EN
Installation of the DUPLEX TA Module
The DUPLEX TA module is designated for installation into the Aurora 9 transmitter. The TA module is delivered without
antenna and case. For this purpose take advantage of the original antenna and case of the Hitec module which have
been delivered with the transmitter.
Assembly of the DUPLEX TA Module :
During installation of the module be sure that the transmitter is switched off!
1. From the back of the transmitter carefully remove the original transmitter module and simultaneously loosen by
slightly turning the transmitter antenna, which is connected by a cable to the transmitter module. Instructions for the
removal of the antenna and module you may find in the manual of the appropriate transmitter module.
2. Disassemble the original transmitter module case, held together by sidewise positioned screws, by unscrewing
and removing these screws.
Transmitter modules