User manual

3. After removal of the case disconnect the antenna

cable from the connector of the original module

4. Open up the hole for the originally used push

button in the case to 6 mm dia.

5. Connect the antenna cable to the TA transmitter

module connector and put everything back into the

case.

6. Close the case again by means of the two screws,

shift the antenna in place and plug-in the module back

into the transmitter.

7. Place a new sticker DUPLEX EX, as delivered with

the TA module, over the original module sticker.

Now the module must be paired with the receiver, see

ELECTROSTATIC SENSITIVE DEVICE

OBSERVE HANDLING PRECAUTIONS

Putting into operation

Pairing with the receiver and performance verification

Any receiver and transmitter module takes advantage of digital transfer for communication purposes, in order to

enable direct address communication between the equipment it is necessary to apply the so called pairing between

them. The description of a transmitter module is given by its unique address which after pairing to the receiver

ensures, that the receiver will accept only data from this definite transmitter. There may be paired as many receivers as

you like with the transmitter module, but a receiver can be paired to one transmitter only.

Install the receiver into your model. If the equipment is switched on first time we explicitly recommend to ensure that

no detrimental effects on health or property may occur due to unexpected receiver output conditions (for instance

badly adjusted mixers, reversed outputs etc.).

Activate receiver pairing by means of the shorting plug (BIND PLUG), which is a part of the receiver.

below. Be careful when switching on the transmitter Aurora 9, the module is not switched on as long as the

transmitter is not in transmitting mode. You will recognize the switch-on state of the module when the red LED starts

blinking. The blinking red LED on the module indicates communication between module and transmitter. At the

transmitter working in Duplex mode moreover a green LED will turn on.

Disassembled module Aurora

UFL connector

Transmitter modules