User manual

Connection of the JETIBOX
As already mentioned the JETIBOX terminal can be connected to DUPLEX Tx transmitters. With the help of this
terminal transmitter data and parameters as well as currently connected equipment (receivers, telemetric senzors
etc.) may be displayed and adjusted.
DUPLEX transmitter modules are equipped with a three pin connector (see marking) intended for connection of the
JETIBOX. Connection can be easily done by the interconnection cable delivered with the JETIBOX. When connecting
pay attention to correct orientation of the connectors. We recommend to connect or disconnect the JETIBOX only, if
the transmitter is switched off. When the transmitter has been switched on you will be able to skim through items of
the transmitter or other connected equipment with the help of the JETIBOX push buttons.
Parameter Adjustment with Help of the JETIBOX
When connecting the JETIBOX terminal to the transmitter you may select whether you want to display and adjust
transmitter parameters (Tx), connected receivers (Rx) or other equipment (Mx) which is able to communicate with
the JETIBOX. Communication with Rx and Mx is only possible if the transmitter module and receiver are paired and if
there exists a radio link. This situation is shown in the LCD display by a downward showing arrow beside the Mx and Rx
text.
After adjustment of the claimed item (Tx/Rx/Mx) push the button D (downward arrow). Afterwards you may skim
with help of pushbuttons through the menu of the selected equipment. When working with equipment Rx or Mx you
may get back to the transmitter module menu Tx by holding down button U (arrow upward) for a time longer than 2
seconds.
When scrolling positions Tx/Rx/Mx with the button R (arrow right) basic telemetric data can be shown. In the first line
of the JETIBOX display you will see the RX antenna voltage as well as the receiver supply voltage. The second line
shows values of the telemetry senzor, which is connected to the receiver input Ext. These Data are copied from the
second line of the actual data display of the connected senzor or from the Expander. If there is no gadget connected to
the receiver input Ext., the second line of this menu position will show now data.
Summary of Transmitter Items:
The introductory display shows the transmitter type. By pushing button R (right arrow) the identification numbers of the
transmitter module and of the actual paired receiver are displayed.
FW ver. 3.00 – Firmware-Version of the transmitter module. New versions are available on the internet pages of
www.jetimodel.com .
Diag – shows more detailed informations about the transmitter and paired receiver condition.
Identification of the active receiver antenna (A1/A2) and of the actual signal intensity rated from 0 to 9 (best).
On the right side according to condition the following indicators may be shown:
R - Range Test mode (range test)
EN
Transmitter modules