User manual

Mx Tone 1 - enables adjustment of warning tone frequency (Hz), which reveals alert conditions of the connected

equipment Mx (usually a telemetric senzor). A value of 0 indicates that the warning tone is switched off.

Mx Tone 2 - enables adjustment of information tone frequency (Hz), which informs about the alert condition of the

connected equipment Mx. This tone has Morse alphabet character and follows immediately after the warning tone. A

value of 0 indicates that the information tone is switched off.

Acoustical Condition Signalling

All types of transmitter modules are equipped with an acoustic output which is utilized for signalling of different

transmitter, receiver or attached telemetric senzor conditions. The following conditions are reported by acoustic

signals:

I ( _ _ _ ) 3x long low tone

PPM pulses of the transmitter are not accessible (installation error, PCM mode etc.)

P ( . -) short low tone and consecutive high tone -

a paired receiver has been found

B ( - ) long high beep

low receiver battery supply voltage

T ( * ) short high beep

low transmitter battery supply voltage

S ( * * ) 2x short high beep

there are no receiver data available (bad signal)

R ( . - . - ) alternating short and long tones

Range Test mode (range test)

M alert indication from attached telemetric senzor

first beep (revelation tone) corresponding to adjusted value Mx Tone 1

consecutively a Morse alphabet beep (information tone due to adjustment

Mx Tone 2)

Alert indication by Morse alphabet signal, character of signal is given by the type and adjustment of attached

equipment (receiver, telemetric senzor etc.).

For Tx modules we grant a warranty of 24 months from the day of purchase under the assumption that

they have been operated in conformity with these instructions at recommended voltages and that they

were not damaged mechanically. Warranty and post warranty service is provided by the manufacturer.

We wish you sucessful flying with the products of : JETI model s.r.o. Pribor, www.jetimodel.com

RF Output Power - - allows setting an output power of Tx module. (Maximal output power can differ in

different countries, according to local rules)

- transmitting in 2.4 GHz band with max. power 10mW

- transmitting in 2.4 GHz band with max. power 100mW (recommended setting)

- transmitting in 2.4 GHz band operates in combination of 10mW and 100mW max.

power

Transmitter modules