User manual

computer radio control system

2.2.

you observe the wires that pass through the stick shaft and

through the gimbal opening in order to prevent damaging

the connecting cables. The safest method is to remove the

small set-screw from the side of the stick housing to allow

the switch or knob internals to remain stationary while

you rotate the stick housing for height adjustment.

11. Pass the switch wires through the same gimbal opening as the

hall sensor cable (through the center of the gimbal assembly).

12. Next insert wire ends through the opening of the printed circuit

board and solder them to the matching soldering points in such

a way that the same color wires lay on the top of each other.

13. Carefully move transmitter sticks to their full outside positions

in order to make sure that you have sufficient wire length and, if

needed, adjust accordingly. The connecting cables for

all moving parts of the unit should have sufficient length in

order not to be exposed to any mechanical damage and any

bending stresses.

14. Install the stick unit assembly back into its correct position.

15. Install and secure the machine screws for the control stick

assembly.

Installation and Configuration of Gimbals Switches

After the switch has been installed into the stick assembly you have

to re-configure and enable it in the transmitter software before it will

function properly. This can be done in the transmitter menu „Main

menu->Advanced setup->Sticks/ switches setup“, see section

9.3.2.

16. Connect the control stick assembly wires to the Tx board

connector (3 wires ). Pay close attention to the wire X, Y, S

lengths. Connect the longest wire as the first one from the

outside of the transmitter (3 connectors ).X, Y, S

17. Secure the stick assembly wires into their holders.

18. Mount the "T" plate back into place. First insert the connectors

of the "T" printed circuit board into the body of transmitter and

then carefully insert the "T" plate into its connectors on the

main board. Be careful while handling the wires underneath the

"T" plate to avoid any resistance when installing the "T" plate. If

the wires cause any resistance or if the wires are pinched or

stressed in any way, please re-route the wires and try the "T"

board installation again.

19. Reinstall the "T" plate mounting screws.

20. Reconnect transmitter battery pack and reinstall radio back

cover and cover screws.

XXX

YYY

SSS