User manual

computer radio control system

2.2.

Switch Exchange:

1. Switch off the transmitter and remove the 10 screws that secure

the radio back cover. Next, remove the radio back cover.

Be sure to disconnect the transmitter battery pack

connector.

2. With the specialized wrench (not included) carefully loosen and

remove the switch installation nut.

3. Carefully hold the switch by its printed circuit board assembly

and slowly pull it out. Use this method to also remove and

exchange all of the other switches. After re-assembling and

turning on your transmitter the software will sound a warning

reminding you that you have executed a change. Always re-

inspect all assigned functions of the switches before

attempting to fly.

3.5 Digital Trims

Transmitter gimbals are used for controlling the basic flight

functions like throttle, roll(aileron), pitch(elevator), and yaw(rudder).

Immediately under the transmitter gimbal sticks you can see four

push-buttons which are the programmable, digital trim buttons.

The digital trims are used for fine trimming of the flying model. When

the transmitter is turned off, the trim values are stored in memory

and are recalled when the system is turned back on.

Every model has its own trim setup. Also all flight modes may be

configured to use different trim configurations. By pressing one of

the buttons, the screen will automatically change to display the

graphic position of that trim. The transmitter trims feature an

acoustic step and centre beep alarm.

In the „Digital trim“ menu it‘s possible to enable a special

function used as automatic trimming. Digital trim steps and trim

range setting is explained in „Main menu->Fine tuning/flight

modes->Digital trim“